Broken Spring Repair

Broken Spring Repair – For more than 20 years we have been repairing Broken Garage Door Springs in Parker Colorado and the sounding area. It is one of the most common garage door repairs.

Every garage door spring replacement job begins with full inspection of the garage door, which will include; evaluating the full extent of the repair, measuring the garage door spring size and confirming it is the correct size to support the weight of the door. Our garage door repair technician will go over the estimated cost for the repair and will begin the garage door repair jobs upon approval.

*Every broken spring repair price for residential garage doors is based of *$85 flat rate for labor (*$99 for weekend, holidays and after hours) plus the cost of the spring. Spring size vary by size and starts at $79 per spring.

Garage Door Torsion Spring Issues may be:

Old Springs – Your garage door’s springs are arguably the most important and most dangerous part of your door. Springs wear out. When they break, injury can result. If you have an older garage door, have your springs inspected by a professional technician and replaced if needed. If your door has two springs, both should be replaced, even if one is not broken. This will not only prevent any damage caused by the breaking of the second spring, but also keep your door working efficiently.

Loud Springs – Springs can squeak and be noisy. This is caused by normal use and does not necessarily indicate a problem. Before calling a professional service technician, use a spray-on lubricant (recommended especially for garage doors). If the noise persists, call a professional garage door installer for service. WARNING – Springs are under high tension. Only qualified persons should adjust them.

Garage door springs, cables, brackets, and other hardware attached to the springs are under very high tension and, if handled improperly, can cause serious injury. Only a qualified professional or a mechanically experienced person should adjust them, but only by carefully following the manufacturer’s instructions.

The torsion springs (the springs above the door) should only be adjusted by a professional. Do not attempt to repair or adjust torsion springs yourself.

A restraining cable or other device should be installed on the extension spring (the spring along the side of the door) to help contain the spring if it breaks.

WARNING – Never remove, adjust, or loosen the screws on the bottom brackets of the door. These brackets are connected to the spring by the lift cable and are under extreme tension.